Marine Division · Bellingham, WA Mon–Thu 7:30 am–4:30 pm · Fri closed Questions? (360) 734‑8509 · Send us a message
Coastline Equipment, Marine Division - home Estimate (0)

Print this sheet and mark where every fitting goes. Then photograph or scan it, open your Estimate on the website, fill in your details, and upload it under Drawings & photos. A sketch on plain paper works too.

Back to the tank builder
Coastline Equipment, Marine Division

Tank markup sheet

coastlinemarinetanks.com/contact
(360) 734-8509 · ask for Marine Sales
1. Check the dimensions. They're filled in from the builder.
2. Number every fitting on the drawings with a dot: 1, 2, 3… The list below is started from what you picked.
3. Say where each one goes: which face, and how far from the forward end, the port side, and the bottom.
4. Photograph or scan it and upload it on your Estimate, under Drawings & photos.

Top view (looking down)

Aft end (from behind, facing forward)

Port side (seen from outside the tank)

Your tank

How does it sit in the boat?
Length runs fore and aft, as drawn
Length runs side to side: cross out FORWARD and AFT and write which end faces port

Fitting list (measure to the center of each fitting, in inches)

Nothing is cut until you approve the construction drawing we send you. Coastline Equipment, Inc. · Marine Division · Bellingham, WA