Belly tanks: extra gallons where the bilge allows
A belly tank's long side walls slope inward below the straight sides to a narrow flat bottom that runs the full length. The belly settles into the deadrise of the hull. The deep centerline keeps the fuel pickup submerged in chop and adds capacity a flat-bottomed tank can't reach.
Good for
- Flats skiffs and shallow-draft hulls with limited tank height
- Compartments with a recess or bilge pocket under the sole
- Builds where an always-fed pickup matters more than a flat bottom
Two extra numbers
Beyond length, width and overall height, a belly tank needs the belly drop (how tall the sloped section is) and the bottom width (the narrow flat bottom the sides slope in to). Height is the overall height, top to flat bottom, so the drop is part of it.
The pickup sits in the belly
We put the pickup at the bottom of the belly so it stays wet when you're low on fuel and running in a chop. That's the main reason to choose this shape.
Capacity shown is the inside volume at a 1/8″ aluminum wall, calculated from your overall dimensions, and is an estimate; the construction drawing you approve governs the final build.